AAA 12V Marine Bilge Alarm and Pump Control Panel with Audible Warning - RWB2109 RWB2109

AAA 12V Marine Bilge Alarm and Pump Control Panel with Audible Warning - RWB2109

This bilge-pump control panel provides a clearly identified operating point for a compatible marine pumping system. It is useful when replacing a worn panel or planning the controls for a new installation. The switch arrangement, supply voltage and panel dimensions should be matched to the boat’s pump and its method of automatic control.

Moulded pre-wired panel with red warning light and audible alarm, LED power light, fuse holder/fuse and auto/off/manual switch with spring return. Requires two float switches and one pump, purchased separately.

Choosing and using this product

Check the front-panel dimensions against the available dashboard or bulkhead area, then allow room behind it for terminals, cable bends and service access. A panel’s outside dimensions do not establish the size of its cut-out. Confirm the mounting and wiring details from the current instructions before making a new opening or altering an existing one.

Automatic operation depends on the rest of the pump system being correctly configured. This alarm installation requires two separate float switches and one pump; those components are purchased separately. Match it to the pump and the required separate float switches, and ensure that each electrical rating is suitable for the load. Use a qualified marine installer to check circuit protection and the final wiring arrangement.

Once fitted, test each available operating mode with the connected equipment and verify that any indicator behaves as intended. Keep the controls visible and accessible, and make their operation familiar to everyone who regularly uses the boat. Periodically inspect the panel and its connections for moisture, looseness or damage. Replace suspect components rather than relying on an intermittent switch in a bilge-pumping circuit.

When comparing replacement options, use the product code and the stated application together. Check the existing installation before ordering so that the selected component matches the equipment already on board.

Product details

• Panel: 115 x 63mm. 12V only.
• Product code: RWB2109.