Skip to main content
RHS Boating & Marine

Nylon Well Drain with 25mm Cut-Out and Push-On Flange for Marine Use - RWB1435 RWB1435

$2.49 each
Brand: RHS Boating & Marine – Boat Parts, Marine Accessories & Boating Supplies

+
–
The add to cart button will appear once you select the values above

Nylon Well Drain with 25mm Cut-Out and Push-On Flange for Marine Use - RWB1435

Length discrepancy: the supplier website title states 57mm, while the catalogue states 58mm total length. Confirm the actual supplied length and fit before purchase; the verified cut-out is 25mm. Nylon Well Drain with 25mm Cut-Out and Push-On Flange. This white nylon well drain has a fine-threaded body and a push-on grip flanged end fitting. It is intended for draining motor or anchor wells and can be cut to the required length. The selected overall length and 25mm cut-out are important when checking how the fitting will span the mounting area. The ability to shorten the drain is useful during fitting, but the required finished length should be established before any cutting begins.

Choosing and using this product

Measure the thickness and shape of the area the drain must pass through, and check that both ends can seat as intended. Confirm the 25mm mounting-hole requirement and allow for the flange arrangement rather than considering only the tube length. Plan the discharge path so the drain can carry water away from the well without an obstruction at either end. If the drain is connected to or affects a hull-related outlet, assess that arrangement with suitable marine guidance. Before cutting, mark the required length carefully and check it against the actual installation. Make a clean cut and remove debris so the finished edge does not interfere with assembly. Fit the flanged end correctly and follow appropriate sealing and installation practice for the boat. After fitting, run water through the well and inspect the drain and surrounding mounting area for leakage or retained water. Keep both openings clear of sand, leaves and fishing debris. Recheck the fitting during normal cleaning and after any impact or work around the well. A drain that has been cut cannot be made longer, so select a starting length that accommodates the measured installation.

Product details

  • Length discrepancy: the supplier website title states 57mm, while the catalogue states 58mm total length. Confirm the actual supplied length and fit before purchase; the verified cut-out is 25mm.
  • White nylon well drain; 25mm cut-out; total length requires confirmation.
  • White nylon fine-thread drain with push-on flanged end; cut to length for motor or anchor wells.
  • Product code: RWB1435.