Marinco AFI Fullblast Marine Dual Air-Electric Trumpet Horn - Chrome Brass, 24V RWB623
The Marinco AFI Fullblast 24V dual trumpet air-electric horn combines chrome-plated solid brass trumpets with a supplied compressor. It suits a planned installation where a dual-tone horn and its air-system components are wanted together.
Dual-tone solid-brass trumpet horn with a non-corrosive Lexan diaphragm. Kit includes mounting bracket, air compressor, air tubing, fittings and mounting hardware.
- Size: 425 L x 175 W x 95mm H
- Sound rating: 121dB
- Frequency as listed: 375 +/-15, 315 +/-15
- Finish: chrome-plated brass
- Voltage: 24V
- Current: 10A
The solid-brass trumpets use a non-corrosive Lexan diaphragm and produce the deep, distinctive tone described for the Fullblast range. The kit format brings together the horn mounting bracket, compressor, air tubing, fittings and mounting hardware, giving you a defined set of components to lay out before installation.
This version uses a 24V supply and has a listed current of 10A. Check those details against the boat’s electrical system before selecting the model. Have the cable run, switching and circuit protection reviewed for the actual installation, following the manufacturer’s instructions for both the horn and compressor.
The listed horn dimensions are 425mm long, 175mm wide and 95mm high. Plan room for the compressor and tubing as well as the visible trumpet assembly. Before drilling, consider access to the mounting points, the route of the air line and the ability to inspect each connection later.
The chrome-plated brass finish gives this version a bright exterior. When coordinating it with other onboard fittings, balance the appearance of the trumpet location with practical access to its mountings and the route back to the compressor.
Use the stated 121dB sound rating and dual-tone specification as comparison information when selecting signalling equipment. Confirm suitability for the vessel and intended activity, then test the complete installation as directed before putting it into normal service.
When planning a 24V boat refit, consider the trumpet mounting area together with the compressor location. Trace the tubing route before choosing the final positions for the kit components.