Skip to main content
RHS Boating & Marine

White Large Oval Marine Polypropylene Rod Holder, 30 Degree Shaft 240mm RWB2809

$6.99 each
Brand: RHS Boating & Marine – Boat Parts, Marine Accessories & Boating Supplies

+
–
The add to cart button will appear once you select the values above

White Large Oval Marine Polypropylene Rod Holder, 30 Degree Shaft 240mm

The RWB2809 is a white UV-stabilised polypropylene rod holder with a large oval head and a moulded gimbal in the shaft base. Its shaft is angled 30 degrees, providing a defined rod position for a suitable gunwale installation. The broad oval head and 43mm bore are important measurements when comparing it with narrower rod-holder styles.

Choosing and using this product

Check that the 105 × 84mm head fits the available surface without overlapping a raised edge, trim strip or nearby fitting. The head footprint is larger than the 50mm cut-out, so both measurements matter when planning a new hole or replacing an existing holder. Measure the rod handle too, allowing it to seat in the 43mm bore without forcing it.

Inspect below the gunwale for the full 240mm shaft length and its angled path. Keep the proposed opening clear of wiring, plumbing and structural members. Trial-position a rod and reel to check removal clearance, rod-tip direction and access for the angler. Confirm the final cut-out shape and fastening pattern from the actual fitting before drilling.

Use suitable fasteners and backing for the boat construction, and tighten evenly without distorting the polypropylene head. Inspect the moulded gimbal and test how the rod butt sits before use. Rinse salt and bait residue away after fishing, check for cracks or movement at the fastening points, and keep the opening clear of debris.

This uncapped version is useful where you prefer a simple open holder. If a covered opening is important to the installation, compare the separately listed capped versions rather than assuming a cap is included here.

Check the 30-degree shaft direction carefully before committing to the final mounting-hole positions.

Product details

  • Product code: RWB2809; colour: white.
  • UV-stabilised polypropylene with large oval head.
  • Head size: 105 × 84mm; length: 240mm.
  • Shaft inside diameter: 43mm; cut-out hole: 50mm.
  • Three 5mm countersunk fastening holes.
  • Moulded gimbal in base; supplied individually.
  • Shaft angle: 30 degrees.