No. 6 Rubber Bung Marine Accessories Boating Equipment Stopper Drainage
Choose the No. 6 tapered rubber bung when its 14–18mm diameter range suits the opening. The taper gives the bung a smaller end and a larger end, so both measurements matter when assessing the fit.
This code is supplied as bulk packs of 20. Check that the pack format matches the quantity you intend to order, especially when comparing the bulk and prepacked versions of the same numbered bung.
Measure the opening and compare it with the 14mm minimum and 18mm maximum diameters. The bung number identifies the size option, but should not replace a dimensional check.
Choosing and using this product
For a replacement, inspect the existing fitting and adjoining hose before ordering. Consider the direction of the connection as well as its size. An elbow, straight fitting or barbed tail changes the route and clearance needed even when the nominal connection size is similar.
Keep service points accessible and follow the relevant system instructions for fastening, sealing and hose support. Avoid forcing a hose or thread to compensate for an unsuitable fitting. Confirm the finished connection and normal system operation before putting the installation back into use.
Check the stated contents when putting together the plumbing run. A fitting-only listing does not necessarily include hose, clamps, seals or a mounting assembly. Lay out the required connections before installation so the finished arrangement can be checked as a whole.
When comparing alternatives, use the specified material and intended application rather than assuming every marine fitting is suitable for every liquid. Keep the part reference with the plumbing records so future spares can be matched to the connection actually installed.
Plan the connection from the system outward: identify the fluid application, mating thread or hose size, and the space available for the fitting. A nominal pipe-thread size is a separate measurement from a hose diameter, so compare the correct dimension at each connection.
Product details
- Tapered rubber bung.
- Minimum diameter 14mm; maximum diameter 18mm.
- Supplied bulk in packs of 20.
- Product code: 400521