Bilge Pump Fitting Kit - 3/4” (19mm)
Bring the main discharge connection parts together with this 3/4 inch (19 mm) bilge-pump fitting kit. Product 189650 provides a defined hose size for matching the pump outlet and skin fitting.
The clamshell pack contains 1.5 m (5 ft) of plastic bilge hose, a skin fitting and two stainless steel hose clamps. Check the route length and mounting location before choosing the kit.
The included components relate to the discharge plumbing. Match the electrical controls and pump separately, using the actual pump specifications and installation requirements.
Choosing and using this product
For a service part, identify the existing pump model before ordering. A motor cartridge, switch, strainer or valve renews only its stated part of the assembly. Check adjacent hoses and connections at the same time so an unrelated problem is not mistaken for a failed replacement component.
Select the pump or service component for the actual job: bilge drainage, fresh water, washdown, livewell circulation and waste handling place different demands on a system. Match the stated application first, then compare the power supply, connections and operating details for this exact version.
A flow figure alone does not describe the complete installation. Hose routing, outlet height and the rest of the plumbing can affect the delivered result. Use the relevant pump guidance when sizing the system rather than treating a catalogue flow figure as a guaranteed output at every outlet.
Allow practical access for inspection and servicing when deciding where the equipment will sit. Check the electrical and plumbing connections against the product instructions, and verify the finished system under its intended operating conditions. Keep the model reference accessible for later maintenance.
Product details
- Hose size: 3/4 inch (19 mm)
- Hose length: 1.5 m (5 ft)
- Included: plastic bilge hose, skin fitting and 2 stainless steel clamps
- Packaging: display clamshell
- Product code: 189650